Many people wish to close the pool for different reasons. We’ve written this article for those of you who have an inground pool and who want to know the safest way to put a cover on your pool. Check out pool cover in Melbourne for the best ones on the market.
Make a sign on the corners of your cover
This one is a very good tip for those of you who have a pool that’s not rectangular. Sometimes it can get very confusing to unfold a really large safety cover. And sometimes, when you unfold it, you might realize it’s actually backward or upside down. If you mark the corners with different colors – use spray paint – you’ll be able to unfold it without getting disoriented. This will save you a lot of time.
A 12’’ Allen wrench drill extension is good
While dealing with the safety covers, you’ve probably scraped your knuckles against the patio, which means that you’ve probably looked into an Allen wrench extension for your drill so you could screw it in and out the anchors easily. If you didn’t do that, however, you might want to save yourself some effort and time, and buy a drill adapter – which is not that expensive either. Or you could use a hacksaw in order to cut off the end of the standard safety cover. This way, you’ll prevent it from having to huddle the perimeter of the pool.
Keep in mind that you also have to clean the anchors that move up and down. If you don’t, your drill will bind up.
Unroll the cover in an even way
When saying unroll, we actually say folded – two people can grab one end, and it just opens up fast. However, try not to drag it across the ground, because it might tear apart, and also be careful not to rip the raised cover anchor (if it’s already raised). You might need another person to help you with this one, but you could do it by yourself, too. However, it’s a bit difficult. You need to make sure that each side is secured before inclining it to the opposite side. Keep in mind that the safety cover is much heavier when it’s wet, and it is very difficult to pull it out of the water if it goes underwater.
The grid should be your guide
The black seams of the safety cover are seen as a grid that will help you see if you’re lined up with the opposite tension spring. This is very important, especially if you have a pool that’s shaped weird, where it’s actually very hard to see which tension spring attaches to the anchors. It’s not a very nice feeling when you think you’ve put the safety cover in the right way, only to see after that you need to undo everything and start over. Just use the grid – it’s the best one, especially when we’re talking about the initial installation, when you need to center the cover in the right way over the pool, to get a proper anchor placement.
Store it properly
This is a crucial step when it comes to how long you’ll be able to use the cover. You need to clean it before you fold it, and then you need to let it dry outside before you store it.